When using pressure sensors, the output signals 0 ? 20 mA, 4 ? เพรสเชอร์เกจ and DC 0 ? 10 V are generally chosen to ensure that the sensor signals to be evaluated and additional processed. For this, the signal output of the pressure sensor is usually linked to a corresponding input card in the PLC.
In this context it could often be confusing, as the day-to-day usage of the terms ?active?, ?passive?, ?current source?, ?voltage source?, ?current sink? and ?load? เพรสเชอร์เกจ to be wildly mixed together. Any electrical signal processing always takes a voltage supply (an ?active part?) and a ?load?, such as a pressure sensor, which represents the ?passive part?. Sometimes the active the main interconnection is also referred to as a power source/voltage source and the passive part is referred to as a ?current sink?. To ensure that a power circuit can function, current must flow in a circuit ? even when an instrument is normally known as lots, the current isn’t consumed because of it, rather it only flows from the existing or voltage source through the strain and back to the existing source.
This works only when an ?energy gap? exists between current source and current sink, therefore the power source operates actively (= sending out current) and the existing sink passively (= current flows through it) . Therefore, an interconnection of two current sources or two current sinks will not operate normally. This situation is complicated in day-to-day application:
When does a pressure sensor work passively (current sink) so when does it work actively (current source)?
So how exactly does the input card in my PLC operate?
Generally of thumb, you can take into account that 2-wire sensors usually work passively and thus need an active PLC input card. It really is difficult with 4-wire sensors, since, for instance, a 4-wire flow sensor consists of 2 wires for a separate voltage supply and 2 wires for a dynamic or passive 0/4 ? 20 mA signal output. It is therefore vital to check the datasheets for the sensor and PLC input card used.